Owners Manual

Installing a RAID Controller Module Blank

1. Align the blank with the RAID controller module bay.

2. Insert the blank into the chassis until it clicks into place.

Removing a RAID Controller Module

CAUTION: Many repairs may only be done by a certified service technician. You must only perform

troubleshooting and simple repairs as authorized in your product documentation, or as directed by the online or

telephone service and support team. Damage due to servicing that is not authorized by Dell EMC is not

covered by your warranty. Read and follow the safety instructions that came with the product.

1. Disconnect the cables that are connected to the RAID controller module.

2. Push down on the release tab, and pull the release lever away from the chassis.

3. Hold the release lever, and pull the module away from the chassis.

NOTE: To avoid damage to the sensitive EMI contacts on the RAID controller module, do not stack RAID controller

modules.

Figure 15. Removing and Installing a RAID Controller Module

a. RAID controller module

b. release tab

c. release lever

Installing a RAID Controller Module

CAUTION:

Many repairs may only be done by a certified service technician. You must only perform

troubleshooting and simple repairs as authorized in your product documentation, or as directed by the online or

telephone service and support team. Damage due to servicing that is not authorized by Dell EMC is not covered

by your warranty. Read and follow the safety instructions that came with the product.

1. Insert the RAID controller module into the RAID controller module bay until it seats into place.

2. Push the release lever toward the chassis until it clicks into place.

3. Connect all the cables to the RAID controller module.

Installing Array Components