Users Guide

Setting Up Remote Replication On The MD Storage Array

NOTE: You must activate the Remote Replication premium feature before performing the steps below. For step-by-

step instructions on using MD Storage Manager (MDSM) to set up Remote Replication, see the Administrator's

Guide for your array at dell.com/support/manuals.

Before installing and configuring SRM, you must set up Remote Replication on each MD storage array used in the

recovery solution.

NOTE: Setup of Remote Replication on iSCSI based PowerVault storage MD Series array is governed by iSCSI

array documents available on dell.com/support/manuals.

To set up Remote Replication on the storage array:

1. Start MD Storage Manager (MDSM) on your management host.

2. Open the Enterprise Management Window (EMW) and discover both the protected and recovery site's storage

array.

3. Open the Array Management Window (AMW) for the protected site's storage array and identify a virtual disk to be

used in the recovery solution.

4. Open the AMW for the recovery site's storage array and create a similar-sized, remotely replicated virtual disk.

5. Right-click on the protected site's storage array virtual disk and select Create Remote Replication

6. Select the settings appropriate for your environment and allow remote replication to synchronize.

7. Repeat these steps for:

a. Each virtual disk to be remotely replicated

b. Each storage array in the recovery solution

主机至存计计列配置

计了确保配置的最佳性能和适当的多路径，计接受保计和恢复主机站点与存计计列的交计机计构和 iSCSI 必计

正确配置。下计展示了提供完全冗余的基本配置：