Dell PowerVault MD3460/3860i/3860f Storage Arrays Getting Started Guide Regulatory Model: E08J Series Regulatory Type: E08J001
Notes, Cautions, and Warnings NOTE: A NOTE indicates important information that helps you make better use of your computer. CAUTION: A CAUTION indicates either potential damage to hardware or loss of data and tells you how to avoid the problem. WARNING: A WARNING indicates a potential for property damage, personal injury, or death. © 2013 Dell Inc. All Rights Reserved.
Installation and Configuration WARNING: Before performing the following procedure, review the safety instructions that came with the system. Unpacking A Rack System WARNING: The weight of your system without the physical disks installed (empty weight) is 19.50 kg (43.0 lb) and when fully populated with all the physical disks is 105.20 kg (232.0 lb). WARNING: Your system must be installed by Dell certified service technicians.
Opening And Closing The Disk Drawer Figure 2. Opening and Closing the Disk Drawer Open the disk drawer to install or remove the physical disk carrier(s). NOTE: You can open only one disk drawer at a time. Forcing to open more than one drawer at a time may damage the assembly or produce unexpected results. Installing The Physical Disks Figure 3. Installing the Physical Disk(s) Install physical disk(s) in the disk drawer. NOTE: You may receive multiple drives with carriers in separate boxes.
Connecting The Power Cable(s) Figure 4. Connecting the Power Cable(s) Connect the system’s power cable(s) to the system. Securing The Power Cable(s) Figure 5. Securing the Power Cable(s) Open the cable retention bracket by pulling the tabs on its sides, insert the cable, and secure the system power cable, as shown in the illustration.
Turning On The System Figure 6. Turning on the System Turn the power switch on the back of the system to the On position. The power LED will turn on. Installing The Bezel Figure 7. Installing the Bezel Install the bezel as shown in the figure. Dell Software License Agreement Before using your system, read the Dell Software License Agreement that came with your system. You must consider any media of Dell-installed software as BACKUP copies of the software installed on your system’s hard drive.
Other Information You May Need WARNING: See the safety and regulatory information that shipped with your system. Warranty information may be included within this document or as a separate document. • The Owner’s Manual provides information about system hardware features and describes how to troubleshoot the system and install or replace system components. This document is available online at dell.com/support/manuals.
Power Voltage 220 V AC, autoranging, 50 Hz/60 Hz NOTE: This system is also designed to be connected to IT power systems with a phase to phase voltage not exceeding 230 V. Battery 6.6 V DC, 1100 mAh, 7.26 W Lithium Ion Battery Physical Height 177.80 mm (7.0 inch) Width 482.60 mm (19.0 inch) with rack latches Depth 825.50 mm (32.5 inch) without bezel and handle Weight (maximum configuration) 105.20 kg (232.0 lb) Weight (empty) 19.50 kg (43.
Environmental Maximum shock Operating One shock pulse in the positive z axis (one pulse on each side of the system) of 31 G for 2.6 m in the operational orientation. Storage Six consecutively executed shock pulses in the positive and negative x, y, and z axes (one pulse on each side of the system) of 71 G for up to 2 m. Altitude Operating –30.5 m to 3048 m (–50 to 10,000 ft). NOTE: For altitudes above 2950 ft, the maximum operating temperature is derated 1.8 ºF/1000 ft.
Environmental NOTE: Applies to data center and non-data center environments. Gaseous Contamination NOTE: Maximum corrosive contaminant levels measured at ≤50% relative humidity 10 Copper Coupon Corrosion Rate <300 Å/month per Class G1 as defined by ANSI/ ISA71.04-1985. Silver Coupon Corrosion Rate <200 Å/month as defined by AHSRAE TC9.9.
