Users Guide

Chapter 5 Configuring Your Library
Working With User Accounts
Dell PowerVault ML6000 User’s Guide 103
Figure 15 LDAP Setup
Example
Testing LDAP Settings 5
The Test Settings button tests communication between the library and the
LDAP server, and tests the currently applied LDAP settings. If there are
any problems, an error message identifies the problem area.
If you change the LDAP settings, click Apply to save your changes before
testing them. Otherwise, any changes you made will be lost and will not
be tested.
To test the settings, you must type a user name and password, then click
the Test Settings button. The user you use for the test must be a member of
both the Library User Group and the Library Admin Group on the LDAP
server.
Since most normal users will not be members of both these
groups, you may need to create a special or temporary user specifically
for this purpose.
After configuring LDAP settings, save the library configuration.
The simple LDAP server
configuration shown below would
give the library settings shown at
right.
Simple LDAP Server Configuration: