Users Guide

Chapter 10 Getting Information – Logs and Reports
Viewing the Network Settings Report
Dell PowerVault ML6000 User’s Guide 192
physical SN, logical SN, World Wide Node Name (WWNN), World
Wide Port Name (WWPN), loop ID, topology request, speed request,
actual topology, actual speed, maximum speed, active port (if the
drive has more than one FC port), SCSI ID, SAS address, tape drive
firmware level, control path status, and encryption method of each
tape drive.
• Slots —Type, assigned partition name (storage and import/export
[I/E] station slots only), location coordinates, barcode (storage and
I/E station slots only), media type, element address, encryption
method, get count, get retries, put count, and put retries. If the slot is
a cleaning slot, the cleaning status (usable/expired) and cleaning
count (the number of times the cartridge was used to clean a tape
drive) are also displayed. For more details about slot data, see
Viewing the All Slots Report on page 194.
• Partitions— Name, online status, barcode policy, number of total tape
drives in the partition, number of active tape drives partition, total
media, mounted media, total slots, full slots, total I/E stations, full
I/E stations, and encryption method of each partition.
• Modules (Chassis) — Manufacturer, model type, and serial number of
each module.
You can print the report by clicking on the printer icon in the report
window.
The path to open the report from the Web client is Reports > Library
Configuration
.
Viewing the Networ k Settings Report
The Network Setings Report provides information on the following
library network settings:
• Network — host name, primary DNS, alternate DNS.
• IPv4 Settings — Dynamic Host Configuration Protocol (DHCP)
enabled/disabled, IP address, gateway address, and net mask.