Users Guide

Chapter 12 Installing, Removing, and Replacing
Cabling the Library
Dell PowerVault ML6000 User’s Guide 218
Figure 23 Cabling One or Two
Tape Dr ives Per SCSI Bus
3 Connect the module terminators.
a Using the module terminators, terminate the top and bottom
modules in the library stack. Install one module terminator in the
top terminator connector on the topmost module and one in the
bottom terminator connector on the bottommost module.
If your library configuration consists of a single module, place
module terminators in the module’s top and bottom module
terminator connector.
1 SCSI terminator
2 SCSI drive-to-host cable
3 SCSI cable connecting two SCSI tape
drives
Caution: The module terminator is not the same as a SCSI
terminator. Using a SCSI terminator instead of a
module terminator will damage the library.
One tape
drive per
SCSI bus
Two tape
drives per
SCSI bus