User's Manual

Configure: Library
Note: The Remove DCS No is only available on libraries with the DCS feature.
The following library configuration items are in this menu:
v Mode:
– Random: In random mode, the library allows the server's (host's) application
software to select any data cartridge in any order.
– Sequential: In sequential mode, the library's firmware predefines the selection
of the cartridges. After initialization, the firmware causes the library to select
the first available cartridge found (counting from the I/O Station through slot
23) for loading into the drive.
Important: If a Logical Library in Sequential Mode contains more than one
drive, only the first drive in the Logical Library will be utilized.
Configure
General
Active Slots
Auto Clean
Autoload
Loop
Mode
1
2
Sequential
Random
a77ug056
3 4
I/O Station(s)
enabled
Host Label
Length
Logical Library Settings
Logical Lib Settings
Figure 5-14. Configure: Library menu
5-20 Dell PowerVault TL2000 Tape Library and TL4000 Tape Library User's Guide