User's Manual

Configure: Network
Use these menu items to change the current network settings which allow you to
access the library remotely via a web browser.
v IP Stack - Choose IPv4 only, IPv6 only,orIPv4 & IPv6.
v IPv6 Only and Dual Stack IPv4 & IPv6 - Choose Enable Stateless Auto Config
Address (Web User Interface) or Stateless Autoconfig (Operator Control Panel) if
assigned IPv6 IP addresses are desired. To view the assigned IPv6 addresses
after enabling Stateless Auto Config Address, do the following:
– Operator Control Panel (IPv6 Only): Monitor > Library > Network
If you choose Dual Stack IPv4 & IPv6, you must be prepared to enter both IPv4
and IPv6 IP addresses.
v DHCP - (Dynamic Host Configuration Protocol) If this is enabled, your library
host will negotiate the connection with the library. If DHCP is disabled, the
following information is necessary to establish the remote access.
v IP Address - the IP address of the library
Netmask
Gateway
IP Address
Configure
DHCP-OFF
(IPv4 & IPv4+IPv6)
Network
a77ug0
43
DHCP-ON
IP Stack
Static IPv6
Address
Prefix Length
Ethernet
DHCP-OFF
(IPv6)
Stateless
autoconfig
Gateway
Ethernet
Figure 5-16. Configure: Network menu
5-24 Dell PowerVault TL2000 Tape Library and TL4000 Tape Library User's Guide