User's Manual

Table 8-2. Sub error codes (continued)
38 Error during sled positioning to mail slot in FLMoveSled function
39 Error during sled positioning without sensor
3A Error during elevator movement without sensor
3B Error slot position sensor not found
40 Movement to/from slot failed
41 Error during first slider movement
42 Error during first gripper movement
43 Error during second slider movement
44 Error during second gripper movement, get range failed
45 Error during third slider movement, move home failed
46 Error during set hold current to avoid torsion
47 Negative direction blocked
48 Positive direction blocked
49 Possible motor defect, because both directions blocked
4A Cartridge present sensor defect
4B Inventory lost, because destination possibly full
4C Inventory lost, because source might be empty
4D Could not pull tape out of slot from magazine
4E Unexpected tape on elevator, possible inventory lost
50 Preposition to drive failed
51 Elevator movement to home sensor failed.
52 Sled movement to home sensor failed.
53 Error during sled movement to drive position.
54 Error during rotation to drive position.
55 Error during elevator movement in drive position.
56 Error during sled movement to rotation position.
57 Error during rotation to end position.
60 Move from/to drive failed.
61 Error during first slider movement.
62 Error during first gripper movement.
63 Error during second slider movement.
64 Error during second gripper movement, get range failed.
65 Error during third slider movement, move home failed.
70 Release magazine failed.
71 Error during sled movement to rotation position.
72 Error during rotation to unlock position.
Chapter 8. Error codes 8-9