User's Manual

Table 8-2. Sub error codes (continued)
97 Slot not free at robot unload
98 Cartridge not seated in load phase
Warning events
Warning events that are described are reported by way of email notification. The
Attention LED flashes when warning events for the following occur:
v Media
v Fan
v Redundant power supply
An appropriate message is posted on the Operator Control Panel and the Web
User Interface.
Table 8-3. Warning events
30 SCSI: transport element full
Refer to your host application documentation for problem
determination information.
31 SCSI: all slots empty
32 SCSI: invalid opcode
33 SCSI: invalid element address
34 SCSI: invalid field in CDB
35 SCSI: Invalid drive specified
36 SCSI: SEND DIAGNOSTIC command:
invalid test number
37 SCSI: invalid LUN
38 SCSI: parameter list length error
39 SCSI: parameter list error: invalid field
3A SCSI: parameter list error: parameter not
supported
3B SCSI: parameter value invalid
3C SCSI: saving parameters not supported
3D SCSI: invalid ID message
3E SCSI: destination element full
3F SCSI: source slot or drive empty
40 SCSI: wrong checksum
41 SCSI: command sequence error
42 SCSI: drive disabled
Check your configuration settings.
43 SCSI: I/O Station disabled
44 SCSI: flash image does not fit bootcode
Refer to your host application documentation for problem
determination information.
45 SCSI: media removal prevented by drive
46 SCSI: media removal prevented by
library
47 SCSI: flash image does not fit personality Check the version of firmware that is used for the upgrade.
Chapter 8. Error codes 8-11