User's Manual

Table 8-3. Warning events (continued)
65 Invalid upgrade cartridge. Drive rejected
the upgrade cartridge as invalid
Not supported
66 Medium error; diagnostic tape write
protected
Ensure that diagnostic tape is not write protected.
67 Medium error, incompatible medium for
write operation
Replace incorrect cartridges.
6A Medium error, no OBDR tape Insert OBDR tape.
70 Currently not used
71 Currently not used
72 Currently not used
73 SCSI: overlapped command attempt
Refer to your host application documentation for problem
determination information.
74 SCSI: echo buffer overwritten
75 Download prevented due to
incompatible bar code reader hardware
Older firmware image doesn’t support current bar code
reader hardware. No downgrade possible.
77 Download prevented due to
incompatible LCM
Older firmware image doesn’t support current library
controller hardware. No downgrade possible.
78 Download prevented due to
incompatible Rob Code
Older firmware image doesn’t support current robotics
controller hardware. No downgrade possible.
79 Download prevented due to
incompatible drive version
Use correct drive firmware image.
80 Movement Retry.
81 Fan Alert.
82 Clean request from drive.
83 Media Attention.
84 Drive reported warning or critical tape
alert flag.
85 Network problem. Check network connections, configuration, and settings.
86 Not enough cleaning cartridges present
to autoclean.
Insert more cleaning cartridges to the empty reserved slots.
87 Drive disabled because it is not
supported for use in this library.
Check drive type and install only supported drives.
88 Drive firmware unchanged after
upgrade.
This is normal if the old and new drive firmware is the
same version.
89 Power Supply Fan operation warning. Check the power supply status.
8A Power Supply failed. Check the power supply status and replace the failed power
supply.
8B Power supply failed. Check the power supply status and replace the failed power
supply.
8C Invalid Robotic Code. Install the latest version of library firmware.
8E Cleaning tape nearly expired. Continue with cleaning cartridge until it is expired, then
replace the expired cleaning cartridge with a new cleaning
cartridge.
8F I2C bus recovery. Run library System Test.
92 VPD data have been restored from
EEPROM.
This is normal when the VPD is restored EEPROM.
Chapter 8. Error codes 8-13