User's Manual

a. Rack Kit A: The following parts make up Rack Kit A.
v Packaged in cardboard material:
– 2 rails (not shown) See Figure 4-9 on page 4-9 for a graphic of the rails.
– 2 mounting brackets (1 in Figure 4-6)
v Packaged in the small bag with no label:
– 1 Torx wrench (5 in Figure 4-6)
– 2 anchors (4)
– 2 countersunk screws for securing the anchors (6)
– 2 small countersunk screws for securing the tops of the mounting
brackets (7)
– 2 large screws to secure the mounting brackets to the rack (8)
v Packaged in the small bag with "Round Hole" on the label: 9 screws to be
used on racks with round holes. (2)
v Packaged in the small bag with "Square Hole" on the label: 9 screws to be
used on racks with square holes. (3)
Note: Eight (8) screws are needed for the installation. One additional screw
is provided for security.
4
a77ug275
1
3
2
8
5
6
7
Figure 4-6. Rack Kit A mounting hardware
Chapter 4. Installation and Configuration 4-7