User's Manual

6. Install the library mounting brackets (1) as shown on the 2U library on each
side of the library using the screw that was removed from your library and an
additional short, counter-sunk screw included in the rack kit. (The 4U rack
anchors and mounting brackets are similar.)
7. With library rack anchors and mounting brackets installed, slide the library
onto the rails (as shown in Figure 4-15 on page 4-14 and Figure 4-16 on page
4-14). Gently push the library into the rack to lock the REAR anchors installed
on each side of the library. When the library stops, the front mounting brackets
will be flush with the vertical rack rails.
a77ug2
67
Figure 4-14. 2U library side screws to remove
Chapter 4. Installation and Configuration 4-13