User's Manual

Note: If you attempt to enter a blank value for the Domain Name, a warning
message will appear. It will say If you are using Event Notification then
a value is required for the Domain Name.
7. Click one of the following:
v Refresh - to cancel all of your entries and leave the settings as they were.
v Submit - to apply the changes made to the screen.
Configuring SNMP settings
This page shows the current SNMP configuration of the library and allows
modification to the configuration. When a change is requested, a box checks to
confirm the changes.
Click SNMP in the left navigation pane to display the SNMP page.
Note: For information about SNMP, see “SNMP Messaging” on page 1-7 and
Appendix F, “SNMP Status MIB Variables and Traps,” on page F-1.
Note: If SNMP is not enabled (cleared), all SNMP fields are disabled.
SNMP
v Enabled - Check this box to have SNMP traps sent to an SNMP Management
console.
v Community Name - An SNMP community name is a text string that acts as a
password to authenticate messages that are sent between the SNMP remote
management application and the library. Enter your preferred name, or leave as
"public".
SNMP DESTINATIONS
v Target1-IPAddress - If SNMP traps are enabled, enter an IP address where
SNMP traps are sent.
v Target2-IPAddress - Enter an optional second IP address where SNMP traps
are sent, or leave as 0.0.0.0.
a77ug278
Figure 4-38. Configure Library: SNMP page
Chapter 4. Installation and Configuration 4-35