User's Manual

Figures
1-1. Front panel of a 2U library ......1-1
1-2. Front panel of a 4U library ......1-2
1-3. Rear panel (drive sled only) of a half height
Fibre Channel drive .........1-3
1-4. Rear panel of a 4U library with full height
Fibre Channel drive and half height SAS
drives .............1-3
1-5. Rear panel of a 2U library with a full height
dual port SAS drive .........1-4
1-6. Library drive sled without ESD springs
(SCSI sled shown) .........1-10
1-7. Library drive sled with ESD springs [1]
(SAS sled shown) .........1-10
2-1. Power-ON screens .........2-2
2-2. Web User Interface login page .....2-6
2-3. 2U library System Status screen .....2-6
2-4. 4U library System Status screen .....2-6
2-5. 4U library System Status screen showing
media attention status ........2-7
2-6. 4U library System Status screen showing a
power supply failure ........2-7
3-1. Configuration of a one - partition system 3-4
3-2. Configuration of a two - partition system 3-4
3-3. Configuration of a three - partition system 3-5
3-4. Configuration of a four - partition system 3-5
3-5. Examples of SCSI element addressing 3-6
4-1. Removing the plastic protective sheets from
the library ............4-2
4-2. Installing foot pads on the bottom of the
library enclosure ..........4-4
4-3. Shipping lock and label .......4-5
4-4. Removing the Shipping lock and label 4-5
4-5. Library shipping lock and label storage
location on rear panel of library .....4-6
4-6. Rack Kit A mounting hardware .....4-7
4-7. Rack Kit B mounting hardware .....4-8
4-8. Examples of EIA units for round hole and
square hole installations .......4-9
4-9. Rear view of Rack Kit A which shows the
narrow part of the rail located at the rear of
the rack..............4-9
4-10. Rear view of Rack Kit B shows a different
mounting method .........4-10
4-11. Kit A (top picture with circles) showing
rails installed. Rack Kit B is below showing
the front view of this kit installed.....4-11
4-12. 2U library rack anchors and mounting
brackets ............4-12
4-13. Close-up view of mounting of the anchors
on both sides of the library ......4-12
4-14. 2U library side screws to remove 4-13
4-15. Sliding the 2U library into the rack 4-14
4-16. Sliding the 4U library into the rack 4-14
4-17. Securing the 2U library to the rack 4-15
4-18. Securing the 4U library to the rack 4-16
4-19. Attaching a SCSI host interface cable to the
2U library ............4-17
4-20. Attaching host interface cables to the 4U
library .............4-17
4-21. Attaching a SAS interface cable to the 2U
library .............4-17
4-22. Removing the protective label from the
power receptacle .........4-18
4-23. Log in screen on the Web User Interface 4-23
4-24. The 2U library Configure Library: General
screen.............4-25
4-25. Example: The 4U library Configure
Library: General screen .......4-25
4-26. The 4U library Configure Library: Logical
Libraries page ..........4-26
4-27. The Configure Library: Path Failover
Feature Activation screen
.......4-26
4-28. Feature Key verification screen .....4-27
4-29. Feature Activation Key screen .....4-28
4-30. Configure Library: Encryption Activation
screen.............4-28
4-31. The Configure Library: Drive screen 4-30
4-32. Configure Library: Network Page 4-30
4-33. Warning Screen ..........4-32
4-34. The Configure Library: User Access screen 4-32
4-35. The Configure Library: Date and Time
screen.............4-33
4-36. The Configure Library: Logs and Traces
screen.............4-34
4-37. The Configure Library: Email Notification
screen.............4-34
4-38. Configure Library: SNMP page 4-35
4-39. 2U library left magazine .......4-39
4-40. 2U library right magazine ......4-39
4-41. 2U library I/O station in the left magazine 4-40
4-42. 4U library left magazines.......4-40
4-43. 4U library right magazines ......4-41
4-44. 4U library I/O station in the lower left
magazine ............4-41
4-45. Finger Holes on back side of 4U library
I/O station ...........4-42
5-1. 2U Library Control Keys .......5-8
5-2. 4U Library Control Keys .......5-8
5-3. Operator Control Panel Menu Tree 5-10
5-4. Monitor: Library menu .......5-11
5-5. Monitor: Drive menu ........5-13
5-6. Example of a 4U Monitor: Inventory menu 5-15
5-7. Overview of inventoried cartridges: Left
magazines of a 4U Library ......5-15
5-8. Detailed information on cartridges residing
in a magazine ..........5-16
5-9. Control: I/O station menu ......5-16
5-10. Control: Move Cartridges menu 5-17
5-11. Control: Magazine menu .......5-18
5-12. Control: Re-Inventory menu......5-18
5-13. Configure: Logical Libraries menu 5-19
vii