Installation guide

3. Attach the one-hole lug to the chassis using the supplied 10-32 screw with the captive internal tooth

lock washer. Torque the screw to 20 in-lbs.

Figure 8. Attaching the Ground Cable

a. Lug hole

b. Ground Screw

4. Attach the other end of the ground cable to a suitable ground point. The rack installation ears are not

a suitable grounding point.

Installing the SFP+ and QSFP+ Optics

The S4810–ON has 48 SFP+ optical ports and four QSFP+ optical ports.

WARNING: ESD damage can occur if components are mishandled. Always wear an ESD-

preventive wrist or heel ground strap when handling the S4810–ON and its components.

WARNING: When working with optical fibers, follow all warning labels and always wear eye

protection. Never look directly into the end of a terminated or unterminated fiber or connector

as it may cause eye damage.

To install SFP+ or QSFP+ optics into an open port, follow these steps:

1. Position the optic so it is in the correct position. The optic has a key that prevents it from being

inserted incorrectly.

2. Insert the optic into the port until it gently snaps into place.

NOTE: Both rows of QSFP+ ports require that the 40G optics be inserted with the tabs facing

up.

Install the S4810–ON