Installation guide

Console Ports

You can access the S4810–ON directly through the console port at the input/output (I/O) side of the

system.

Accessing the RJ-45 Console Port (RS-232)

The RS-232/RJ-45 console port is labeled on the upper-right-hand side of the S8410–ON chassis (the

I/O side) (as shown in the following illustration).

NOTE: Before starting this procedure, be sure that you have a terminal emulation program already

installed on your PC.

Figure 12. S4810–ON Serial Console Port Connector

1. RJ-45 Console Port

The following table lists the console port pinout assignments.

To access the console port, follow these steps.

1. Install an RJ-45 copper cable into the console port. Use a rollover cable to connect the S4810–ON

console port to a terminal server.

2. Connect the other end of the cable to the dumb terminal emulator (DTE) server.

3. Keep the default terminal settings on the console as follows:

– 115200 baud rate

– No parity

– 8 data bits

– 1 stop bit

– No flow control

Console Ports