Owner's manual

32 Driver Installation
4 Press <Enter> to load the Linux kernel.
5 At the prompt Please insert the driver update floppy ,
click
OK .
The system selects the driver from the diskette and installs it. The system
then displays the message
DRIVER UPDATE ADDED with the description of the driver module.
6 Click OK .
If you want to install from another driver update medium, continue with
the following steps.
7 The system displays the message PLEASE CHOOSE DRIVER UPDATE
MEDIUM
.
8 Select the appropriate driver update medium.
The system selects the driver from the disk and installs it.
NOTE: SLES 9 Gold media is required when you install any SLES 9 service
pack.
SUSE Linux Enterprise Server 10 Installation and Disk Enumeration
The operating system may not boot when SUSE Linux Enterprise Server 10 is
installed on a system that has the SAS 6/iR controller with more than two
hard drives connected. The issue occurs when the hard drives are configured
with more than one RAID configuration, or when one RAID volume along
with one or two individual disks are connected to the controller. In these
scenarios, the SUSE Linux Enterprise Server 10 installer will install the grand
unified bootloader (GRUB) to the incorrect hard drive. To avoid this issue,
complete the following steps during the operating system installation:
1
Insert the SUSE Linux installation media and proceed with the
installation screens to the
Installation Settings window. Select the
Expert tab, and then select Booting .
2 The Boot Loader Settings window appears.
3 Select the Boot Loader Installation tab and then select Boot Loader
Installation Details
.
book.book Page 32 Monday, September 15, 2008 2:47 PM