Owner's manual

Troubleshooting 53
Integrated RAID
exception detected:
The BIOS detected an exception with one or more
RAID virtual disk. For additional troubleshooting
information, see the error message "Volume
(xx:yy:zzz) is currently in state
“STATE”.
Volume (xx:yy:zzz) is
currently in state
“STATE”
Lists the current state of the specified virtual disk
when it is not optimal. The state may include:
• INACTIVE: The virtual disk is inactive, possibly
foreign, or could be in any one of the states
mentioned below.
• DEGRADED: The virtual disk is in a degraded state
and has lost redundancy.
• RESYNCING: The virtual disk is degraded and
currently rebuilding.
• FAILED: The virtual disk has an error and is in a
failed state.
• MISSING: The virtual disk is no longer present
though a record of it remains.
Device not available Device may not be ready at this time. The device will
be retried. If the problem persists, restart your
system.
Spinning up the
device!
The device currently being scanned is being spun up.
ERROR! Device is not
responding to Read
Capacity
The device did not respond to a read capacity
command. Contact Dell.
Failed to add device,
too many devices!
Could not allocate resources for additional devices.
ERROR! Adapter
Malfunctioning!
The adapter did not initialize properly. There may be
a problem with the adapter configuration. Reload the
BIOS configuration. Invoke the configuration utility
again and see if the issue persists.
MPT firmware fault The LSI Logic MPT firmware faulted. Contact Dell.
Table 7-4. BIOS Error Messages (continued)
Message Meaning
book.book Page 53 Monday, September 15, 2008 2:47 PM