Owner's manual

54 Troubleshooting
Adapter removed from
boot order!
An controller that was previously in the boot order
was not found. It has either been removed from the
system or moved to a different slot.
Updating Adapter
List!
A new adapter was found for which there is no record.
A record will be created for it.
Adapter(s) disabled
by user
An adapter was found, but it has been disabled in the
Configuration Utility and will not be used by the
BIOS.
Adapter configuration
may have changed,
reconfiguration is
suggested!
A controller has been moved or reinstalled in the
system. Add it to the boot order using the available
resources.
Memory allocation
failed
The controller could not allocate enough memory to
load the Configuration Utility, its strings file, or its
options file. Reboot the system.
Invalid or corrupt
image
One of the images for the Configuration Utility, its
strings file, or its options file is corrupt. Reload the
BIOS. Reflash the firmware.
Image upload failed Could not upload the image for the Configuration
Utility, its strings file, or its options file. Reload the
BIOS.Reflash the firmware.
Image not found Could not locate the image for the Configuration
Utility, its strings file, or its options file.
Unable to load LSI
Configuration Utility
Could not load the Configuration Utility. This error
usually follows one of the four previous messages.
Unable to load LSI
Logic Corp MPT BIOS
MRT BIOS Fault 02h
encountered at
adapter PCI (XXh,
XXh,XXh)
Fusion-MPT Firmware
fault code 0706h
The controller was downgraded from the current
firmware revision to an earlier revision which cannot
support the current configuration information and
cannot be initialized. Contact Dell support for
assistance.
Table 7-4. BIOS Error Messages (continued)
Message Meaning
book.book Page 54 Monday, September 15, 2008 2:47 PM