Administrator Guide

• update emm -enc = 500rg67890123456 -emm = 500a123456789012 -file = C:\Users\Administrator
\firmwares\emm_upgrade.esm
• update emm -emm = 500a123456789012 -file = C:\Users\Administrator\firmwares\emm_upgrade.esm
Update Adapter
Description
After running the following command, the updated firmware file’s version is installed.
Command syntax
shmcli (update adapter | updateadapter) ( -a=<(SAS WWID | AdapterIndex)> -file=<FW.FilePath>
| [-h])
Parameters
Table 25. Update Adapter
Parameter Description
-h, -help
Provides more information about the command, description, and
usage.
-outputformat
Following output formats can be specified: XML, JSON.
-a, -adapter
Specifies the adapter to be used for the command. This can either
be the SAS WWID or the Adapter Index.
-file
Specifies the file at the given path used for the command.
NOTE: If the filename contains special characters, you must enclose the file path within escaped double quotation
marks.
Status Adapter
Description
Shows information about the specified adapter status including PHY and expander information.
Command syntax
shmcli (status adapter | statusadapter | sa) (-a=<(SAS WWID | AdapterIndex)> [-
outputformat=<supportedOutputFormats>] | [-h])
Parameters
Table 26. Status Adapter
Parameter Description
-h, -help
Provides additional information about the command, description,
and usage.
-outputformat
Following output formats can be specified: XML, or JSON.
-a, -adapter
Specifies the Adapter to be used for the command. This can either
be the SAS WWID or the Adapter Index.
Global Topology
Description
Shows a global list of all objects in the system. Output is displayed only in XML format.
Update commands
35