Owners Manual

Figure 13. Clip Cable Chains to Chassis Bracket
11 Place the bezel over the front of the tray by pressing the release buttons on the bezel and placing it over the retaining slots on the
tray.
Figure 14. Install the Front Bezel
Modify the Rail Lengths
Use this procedure to extended or shorten the lengths of the expansion enclosure rails.
About this task
The rails have four adjustment ranges: 18-22", 22-26", 26-30", 30-34". The default length of the rails is 22-26".
Steps
1 Orient one of the rails to display the spacing markings on the inside of the rail.
2 Locate the two screws and nuts which hold the length adjustment bracket in place.
3 Using a screwdriver and a 10 mm socket or wrench, remove both screws and nuts.
18
SC460 Expansion Enclosure Installation