Owners Manual

Part Part Number Description

Used to secure the expansion enclosure chassis and top cover to a rack with

#10-32 threaded holes

036-032-012

#12-24 x 1/2 in. truss head Phillips screw with nylon patch (Quantity: 6)

Used to secure the expansion enclosure chassis and top cover to a rack with

#12-24 threaded holes

Steps

1 Remove the semi-captive M5 shoulder screws from the expansion enclosure chassis and top cover.

2 In a rack with without threaded holes, place M5 clip nuts into the mounting holes on the rack that line up with the holes on the

expansion enclosure and top cover.

3 Secure the expansion enclosure and top cover to the rack using the appropriate truss head screws.

Connect the Power Cables

Connect the power cables to the SC460 expansion enclosure.

About this task

Steps

1 Connect the power cables to the power supplies in the expansion enclosure.

Figure 28. Connect Power Cables to the Power Supplies

Left power supply 2 Right power supply

2 Secure each power cable to the expansion enclosure using the strain relief clamp.

3 Connect the power cables plugged into the left power supply to one PDU.

4 Connect the power cables plugged into the right power supply to a second PDU.

5 Label both ends of the power cords to identify the power supply and PDU to which each power cord is connected.

SC460 Expansion Enclosure Installation