Owners Manual
Figure 31. Install the Bezel
3 Push the bezel into place until it attaches to the expansion enclosure.
4 Release the latches on the front on the bezel.
5 If the bezel has key lock, lock the bezel with the key.
Pre-Replacement Procedures
Perform the procedures described in this chapter before replacing a component of the SC460 expansion enclosure.
Send Diagnostic Data Using SupportAssist
Before replacing components, use SupportAssist to send diagnostic data to technical support.
1 Use Storage Manager to connect to the Storage Center.
2 In the Summary tab, click Send SupportAssist Information Now, which is located under SupportAssist Actions in the Status pane.
The Send SupportAssist Information Now dialog box opens.
3 Select Storage Center Conguration and Detailed Logs.
4 Click OK.
Change the Operation Mode of the Storage Center to
Maintenance
Change the operation mode of the Storage Center to Maintenance before replacing components.
1 Use Storage Manager to connect to the Storage Center.
2 In the Summary tab, click Edit Settings. The Edit Storage Center Settings dialog box opens.
3 Click the General tab.
4 In the Operation Mode eld select Maintenance. Selecting Maintenance isolates alerts from those that would occur during normal
operation.
5 Click OK.
Replacing SC460 Expansion Enclosure Components
33