Owners Manual

The location of the failed hard drive is displayed in the Disk View tab.
Figure 33. Disk View Showing the Failed Hard Drive
Remove a Hard Drive
Use this procedure to remove a hard drive from the expansion enclosure.
Prerequisites
1 Use SupportAssist to send diagnostic data to technical support.
2 Change the operation mode of the Storage Center to Maintenance.
About this task
You can remove a hard drive without shutting down the expansion enclosure.
CAUTION
: A drive must be replaced within 10 minutes of extending the expansion enclosure from the rack.
Steps
1 Remove the front bezel.
2 Extend the expansion enclosure chassis from the front of the rack.
3 To release the hard drive, push the orange release tab on the drive carrier towards the front of the expansion enclosure.
4 Lift the latch on the drive carrier and slowly pull the drive up approximately 3 cm (1 in.).
Replacing SC460 Expansion Enclosure Components
35