Owners Manual

Figure 45. Hardware Alert Identifying the Expansion Enclosure with the Failed Power Supply
4 In the Hardware tab navigation pane, expand the expansion enclosure identied in the previous step.
5 Select Power Supplies.
The status of each power supply is displayed in the Power Supplies tab.
6 Select the failed power supply.
The location of the failed power supply is displayed in the Power Supply View tab.
Figure 46. Rear View of the Expansion Enclosure Showing the Failed the Power Supply
Remove a PSU
Use this procedure to remove a power supply unit (PSU) from the expansion enclosure.
Prerequisites
1 Use SupportAssist to send diagnostic data to technical support.
2 Change the operation mode of the Storage Center to Maintenance.
About this task
You can remove a single PSU without shutting down the expansion enclosure.
NOTE
: Make sure the power cables are labeled before disconnecting them from the PSU.
Replacing SC460 Expansion Enclosure Components 45