Owners Manual

Start Up the Storage System and Expansion Enclosure

If the storage system and expansion enclosure were previously shut down, perform this procedure to start them up.

1 Power on the expansion enclosure by plugging the power cables into the PSUs.

NOTE: Wait approximately three minutes for the drives in the expansion enclosure to spin up before powering on the

storage system.

2 Plug the power cables into the power supply/cooling fan modules of the storage system.

3 Power on the storage system by pressing the power switches on both power supply/cooling fan modules to the ON position.

4 Use the Storage Manager to make sure the replacement part is recognized and shown as up and running.

Send Diagnostic Data Using SupportAssist

After replacing components, use SupportAssist to send diagnostic data to technical support.

1 Use Storage Managerto connect to the Storage Center.

2 In the Summary tab, click Send SupportAssist Information Now, which is located under SupportAssist Actions in the Status pane.

The Send SupportAssist Information Now dialog box opens.

3 Select Storage Center Conguration and Detailed Logs.

4 Click OK.

Change the Operation Mode of the Storage Center to Normal

or Production

Change the operation mode of the Storage Center to Normal or Production after replacing components.

1 Use Storage Manager to connect to the Storage Center.

2 In the Summary tab, click Edit Settings. The Edit Storage Center Settings dialog box opens.

3 Click the General tab.

4 Select Normal or Production from the Operation Mode drop-down menu.

5 Click OK.

Replacing SC460 Expansion Enclosure Components