White Papers

30 BP1043 | Configuring Windows Server 2008 R2 for iSCSI SAN Boot with EqualLogic Storage
Figure 15 General parameters for a Broadcom network adapter enabled for iSCSI boot
7. Press [ESC] to return to iSCSI Boot Main Menu, select Initiator Parameters, and press [Enter].
8. Under Initiator Parameters, enter the IP Address, subnet mask, iSCSI Name (optional), and other
details as required.
Note: The server will auto-generate an IQN name for this host. If the target is set to control access based
on IQN name, then add the IQN name to the volume access as shown in Section4, step 5.
9. Press [ESC] to return to the Main Menu, and select 1st Target Parameters and press [Enter].
10. Under 1st Target Parameters, enter the following information:
a. Connect: This option should be enabled
b. IP Address: This should be set to the iSCSI target IP address. For an EqualLogic based target
this will be the Group IP address.
c. TCP Port: Default is 3260. This can be changed to match specific target information.
d. Boot LUN: Default is 0.
e. iSCSI Name: Manually entered IQN name of the iSCSI target.
f. CHAP ID: (optional)
g. CHAP Secret: (optional)