Norris Parts Repair Manual Dell 2000FP Logic Board Installation Instructions Copyright©2006 – All Rights Reserved - Distribution or Duplication of this document is prohibited.
Norris Parts Repair Manual 2 The Dell 2000FP was designed for a wide variety of users ranging from the home, small office, or corporate environment. It utilizes a 20.1-inch (51.0cm) Active Matrix TFT LCD that displays sharp and brilliant images of text and graphics with a maximum resolution up to 1600 x 1200 pixels. Common Problems associated with this model: 1. 2. 3. 4. Black Display (screen goes black). Front Panel Buttons won’t work. Front Panel Lights stay yellow. Picture blurring.
Norris Parts Repair Manual 3 Disassembly Step 1: Remove the four (4) screws from the top of the base. Step 2: Remove the base. Step 3: Remove the four (4) screws from the back cover. Copyright©2006 – All Rights Reserved - Distribution or Duplication of this document is prohibited.
Norris Parts Repair Manual 4 Step 4: Stick a flat screw driver between the back cover and the front bezel on the bottom of the LCD. Step 5: Remove the back cover from the bottom of the LCD. Step 6: Remove the back cover from the bottom of the LCD. Copyright©2006 – All Rights Reserved - Distribution or Duplication of this document is prohibited.
Norris Parts Repair Manual 5 Step 7: Rotate the LCD to the side to continue removing the back cover. Step 8: Rotate the LCD to the other side to continue removing the back cover. Copyright©2006 – All Rights Reserved - Distribution or Duplication of this document is prohibited.
Norris Parts Repair Manual 6 Step 9: Remove the back cover. Step 10: Remove the two (2) screws from the inverter board’s metal cover. Step 11: Remove the inverter board’s metal cover. Copyright©2006 – All Rights Reserved - Distribution or Duplication of this document is prohibited.
Norris Parts Repair Manual 7 Step 12: Remove the fifteen (15) screws from the logic board’s metal cover. Step 13: Remove the logic board’s metal cover. Copyright©2006 – All Rights Reserved - Distribution or Duplication of this document is prohibited.
Norris Parts Repair Manual 8 Step 14: Unplug connector from the logic board. Step 15: Unplug the two (2) connectors from the logic board. Step 16: Unplug connector from the logic board. Copyright©2006 – All Rights Reserved - Distribution or Duplication of this document is prohibited.
Norris Parts Repair Manual 9 Step 17: Unplug connector from the logic board. Step 18: Remove the seven (7) screws from the logic board. Copyright©2006 – All Rights Reserved - Distribution or Duplication of this document is prohibited.
Norris Parts Repair Manual 10 Step 19: Remove the logic board. Step 20 – Reassembly Inspect new part ensuring that any packing materials or tape are removed. Follow the directions in reverse to complete the installation of the replacement part. Make sure that all connectors are plugged in. Make sure that you replace all screws into their assemblies. Copyright©2006 – All Rights Reserved - Distribution or Duplication of this document is prohibited.
