User Manual
Table Of Contents
- Table of Contents
- Introduction
- Safety Warnings
- Installation
- Operation
- Additional UPS Features
- UPS Maintenance
- Specifications
- Troubleshooting
24
|
Installation
Turn the thumbscrew clockwise to secure the bracket.
Repeat to replace the second battery retaining bracket.
13 Remove the front cover from the accessory box (see Figure 16).
NOTE:
Keep the software CD, communication cable, and (if needed) remote emergency power-off (REPO)
connectors in the accessory box until you install the UPS (see page 25).
Figure 16. Unpacking the Front Cover
14 Install the front cover (see Figure 17):
Align the front cover with the front of the chassis.
Insert the right-side tabs on the front cover into tab openings on the right-side chassis.
Push the left side of the cover forward and snap it to the chassis.
NOTE:
Ensure that the LCD panel on the UPS chassis aligns with the LCD window on the front cover before
securing the cover to the chassis.
15 Discard or recycle the packaging in a responsible manner, or store it for future use.