User Manual

Table Of Contents

Operation

NOTE: The UPS does not assume the load if you press the button less than three seconds.

2 Press the button to check for active alarms or notices.

Ignore the “UPS on Battery” notice and notices that indicate missing utility power. Resolve other

active alarms before continuing. See “Troubleshooting” on page 84. After correcting the alarms,

restart if necessary.

You can prevent a battery start (requiring utility power at the next startup) by simultaneously pressing

the

and buttons for three seconds. To disable the battery start, see the Start on Battery setting on

page 50.

UPS Shutdown

To shut down the UPS:

NOTE:

If devices are connected, prepare them to be shut down.

1 Press the button on the front panel for three seconds.

The UPS begins to beep. The UPS transfers to Standby mode.

NOTE:

Releasing the button before three seconds returns the UPS to its original operating state.

2 Switch off utility power where the UPS is connected.

After utility power is removed, the UPS fully shuts down in ten seconds.

Control Panel Functions

The UPS has a three-button graphical LCD. There are three buttons on the control panel: