Manual

Getting Started

Installing the Card

The Dell Network Management Card can be installed in any Dell UPS equipped with a communication

bay without turning off the UPS or disconnecting the load.

To install the Dell Network Management Card:

1 Remove the communication bay cover from the UPS. Retain the screws.

2 If not already done, record the card's MAC address for future reference (see “Installation

Checklist” on page 9).

3 To prevent electrostatic discharge (ESD), place one hand on a metal surface.

4 Slide the card into the open slot and secure with the screws removed in Step 1 (see Figure 4).

Figure 4. Installing the Card

Connecting the Card

To connect the card to the computer and start the configuration:

1 Plug the RJ-45 end of the supplied serial cable into the Settings port on the card (see Figure 5).

NOTE:

You can set the card parameters through the Settings port even if the network is not connected. The

Ethernet port on the card does not work for configuration.

2 Plug the other end of the serial cable into the serial COM port on the computer.