Setup Guide

Connect Parameter: Options
This appendix provides the supported options for the Connect parameter in the following supported connections:
● ICA Connect Options
● RDP Connect Options
ICA connect options
Table shown here contains the supported options used for ICA connections (after you use the Connect=ICA parameter/
selection).
NOTE:
If an option has an underlined value (default), that option and default value will automatically be used with Connect=ICA;
options without underlined values can also be used if you want to, but are not automatically used with Connect=ICA. In
addition, when using options, you can leave the default value or change it to another value shown.
For example, in the following case where:
Connect=ICA
[Option1={0, 1}]
[Option2={1, 2, 3, 4}]
Since you are using Connect=ICA, then Option 1 and its default value 0 will automatically be used as Option 1 has an
underlined value (default of 0). You can still use Option 2 if you want to, however, Option 2 is not automatically used with
the parameter as Option 2 does not have a default value.
NOTE:
Any option in ICA Connect Options that is used in a {username}.ini file will return to the default value set for that option in
the wnos.ini file after a user sign-off. For example, if your {username}.ini file contains the option Reconnect=yes so that a
lost connection will restart 20 seconds after disconnection; and you sign off the thin client, then the Reconnect value will
return to the original default value of no (Reconnect=no) contained in the wnos.ini file—so that others who sign in can use
their own user profile; assuming the administrator has not changed the default values in the wnos.ini.
ICA connect: options
Table 13. ICA connect: options
Option Description
Alternate=[no, yes] Default is no.
Yes/no option to use an alternate IP address returned from an
ICA master browser to get through firewalls.
AudioQualityMode={0, 1, 2, 3} Default is 0.
Specifies the audio quality of a session.
0 – Default
1 – High Quality
2 – Medium Quality
A
100 Connect Parameter: Options