Setup Guide

Parameters for wnos INI files only
This chapter provides the supported parameters that you can use in a wnos.ini file.
NOTE:
For information to help you construct and use the supported INI files, see Getting Started Learning INI File Basics.
Parameters in Connection Settings for wnos.ini Files Only can only be used in a wnos.ini file; they cannot be used in a
{username}.ini file.
To increase usability such as relation to thin client dialog box equivalents, the supported parameters are separated into the
following categories:
● General Settings for wnos.ini Files Only
● Peripheral Settings for wnos.ini Files Only
● Connection Settings for wnos.ini Files Only
NOTE:
The underlined value for a parameter is the default value. Some parameters also have options shown within brackets [ ]. If
an option has an underlined default value, that option and default value will automatically be used with the parameter;
options without underlined values can also be used if you want to, but are not automatically used with the parameter.
In addition, when using parameters and options, you can leave the default value or change it to another value shown. For
example, in the following case where:
ParameterX={yes, no} [Option1={0, 1}] [Option2={1, 2, 3, 4}]
If you use ParameterX, then Option1 and its default value 0 will automatically be used as Option1 has an underlined default
value of 0. You can still use Option2 if you want to, however, Option2 is not automatically used with the parameter as
Option2 does not have an underlined default value.
General Settings for wnos.INI Files only
The following table contains the parameters used for configuring general settings. The underlined values are default values.
Table 4. General Settings: wnos.ini files only
Parameter Description
AutoLoad={0, 1, 2, 101, 102, 201, 202}
[LoadPkg={0, 1, 2}]
[AddPkg={pkg1_name, pkg2_name, …}]
[DelPkg={pkg1_name, pkg2_name, …}]
[VerifySignature={yes, no}]
[UpgradeOrder=(bios, wtos)]
AutoLoad— Default is 1. Specifies the firmware update
mode. The following are the values and associated actions:
0 — Disables checking for image.
1— Enables forced firmware upgrade/downgrade process.
This is the default value.
2 — Enables comparison/non-forced upgrade process only.
101 — Enables firmware upgrade/downgrade process, but
displays a window with OK or Cancel button before the
process with a note of the version to downgrade or upgrade;
displays a status complete window.
102 — Enables firmware upgrade, but displays a window with
OK or Cancel button before the process with a note of the
version to upgrade; displays a status complete window.
3
Parameters for wnos INI files only 11