Setup Guide

Table 4. General Settings: wnos.ini files only (continued)
Parameter Description
on Wyse 3010 thin client with ThinOS platform (T10) only.
This is because there is no local flash on Wyse 3010 thin client
with ThinOS (T10) platform, and the MirrorFileServer
parameter is not supported on it.
EnableGKey={yes, no}
Default is yes.
Yes/no option to enable G key reset. G key reset is supported
for Privilege=High in the NVRAM.
EnableVsync=[yes, no] The EnableVsync parameter enables or disables the Vertical
Synchronization feature. The value is not stored in NVRAM. If
you deploy this parameter on unsupported devices such as
Wyse 3010, 3020 and 3030 LT thin clients, the value is
ignored.
Exit={yes, no, all}
Default is yes.
Specifies the INI file processing.
yes — Processing returns to the prior INI file on the next line
after $include.
no — There is no operation.
all — All INI file processing is exited.
Include=<$mac.ini file or {username}.ini file>
<$MAC.ini> loads /wnos/inc/mac-address.ini.
<$EMAC.ini> loads /wnos/inc/<ethernet 1 interface mac>.ini
<$WMAC.ini> loads /wnos/inc/<wireless interface mac>.ini
NOTE: The file name does not include the symbol : in the
mac address. See also the Exit parameter for information
on how to stop the Include parameter. <{username}.ini>
Loads /wnos/inc/{username}-address.ini. The file name
does not include the symbol : in the {username} address.
See also the Exit parameter for information on how to
stop the Include parameter.
ManualOverride=[no, yes]
[Components={None, display, keyboard, mouse, timezone,
network, audio, printer, language, All}]
The parameter ManualOverride allows the end users to keep
their personalized settings. The default value is No.
If the value is set to No, personalized setting is not allowed.
If the value is set to Yes, the personalized settings are saved
in the device component which can be specified through the
components option.
The parameter Components specifies the component that is
allowed as a personalized setting. Currently the options
supported are None, display, keyboard, mouse, timezone,
network, audio, printer, language, all. The default value is
None.
NOTE:
If the parameter ManualOverride is set, a warning
message is displayed when the users try to reset the
device to allow them to retain the personalized settings or
revert to default settings. The components set using the
INI statements are ignored.
For example,
ManualOverride=Yes
16 Parameters for wnos INI files only