Setup Guide

Table 6. Connection Settings: wnos.ini files only (continued)
Parameter Description
[ConnectionType]={Default, All, RDP, PCoIP,
Blast}
[EnableVDMCredSSP]={yes, no}
[RDCollections={*collect1, collect2,...}]
[DisableShowDisclaimer=[yes,
no]
[DisableShowServer=[yes,no]
[EnableUnauthenticatedAccess]={yes,
no}
[Host={broker_url}]
[AutoConnectList={*|host1;host2;host3...}]
[VMWaitTimer={0–3600}]
[UseRegistrationCode={yes, no}]
[EnableAWSREGCode={yes,no}]
[EnableMFA={yes, no}]
SecurityMode — SecurityMode specifies the security mode for the VMware
broker and Amazon Workspace (AWS) broker. It is only valid in case of
ConnectionBroker=VMware or ConnectionBroker=AWS. The details is as
follows:
● Set SecurityMode=Full to have the Client verify the server's certificate in
highest security mode; if any relevant checks error, it will fail to connect
to the server.
● Set SecurityMode=Warning to have the Client allow connection
continuation in the following two specific exceptions where full
verification would fail:
1. Certificate is self-signed.
2. Certificate has an invalid time.
● Set SecurityMode=Low to indicate that Client allows connection without
any certificate verification.
● Set SecurityMode=Default to indicate that Client follows the
SecurityPolicy setting to verify the certificate.
NOTE:
For Dell vWorkspace broker, ConnectionBroker=Quest is recommended.
EnableVWGateway and VWGateway are used to set the vWorkspace
gateway.
For VMware broker, ConnectionBroker=VMware is recommended.
ConnectionBroker=VDM is still supported but deprecated.
The option ConnectionType specifies the display protocol that you want to
use when launching a session in VMware broker. If this parameter is set, then
the desktops that meet the specified protocol are listed after broker sign on.
This setting is only valid in case of PCoIP feature is supported.
● Set ConnectionType=Default, only the desktops with the default protocol
configured in broker server are listed (this is the default value for this
setting).
● If you set ConnectionType=All, both PCoIP and RDP desktops are listed.
● If you set ConnectionType=RDP, only RDP desktops are listed.
● If you set ConnectionType=PCoIP, only PCoIP desktops are listed.
● If you set ConnectionType=Blast, only Blast desktops are listed.
EnableVDMCredSSP=yes—The option is set to yes to enable RDP NLA
mode connection when the VMware View broker session is launched. The
default value is no. EnableVDMCredSSP=yes works only after you disable
view security tunnel in server side.
RDCollections—The option specifies the collections for Microsoft RD
broker. Only the applications and desktops within the specified collections are
displayed. The value can be a list separated by ',' or ';' and can use wildcard
"*" to match the string. If the parameter is not set, all the applications and
desktops are displayed. To get your RemoteApp or desktops collection name,
do the following:
1. In RDS Server local, go to C:\Users\administrator.RDSS
\AppData\Roaming\Microsoft\Workspaces\{xxxx}
\Resource, and check that all your published collection (.rdp file) are
listed.
Parameters for wnos INI files only
21