Setup Guide

Table 7. General Settings: wnos.ini files, {username} INI, and $MAC INI Files (continued)
Parameter
* Global overrides identically-named user
profile
** After sign off, user profile returns to
global value
Description
Once the restore action is finished, both the Device=DellCmos Action=extract
and Device=DellCmos action=restore must be removed from the related INI
files.
The usage of other settings is self-explanatory. The only condition to use the
setting is the BIOS GUI has such settings.
OSDConfigure—This option enables the thin client to enable or disable the
OSD function.This INI parameter is only applicable to 5470 All-in-one thin
client.
MACPASSConfigure—This option allows the computer to enable or disable
the Integrated MAC PASS Through function. This INI parameter is only
applicable to Wyse 5470 thin client.
USBSidePortTop— If yes is specified, the device attached to the top USB
port on the left-side of the thin client is enabled and available for the
operating system. If no is specified, the operating system cannot detect any
device attached to this port. This INI parameter is only applicable to Wyse
5470 All-in-One thin client.
USBSidePortBottom—If yes is specified, the device attached to the
bottom USB port on the left-side of the thin client is enabled and available for
the operating system. If no is specified, the operating system cannot detect
any device attached to this port. This INI parameter is only applicable to Wyse
5470 All-in-One thin client.
USBRearPortTopLeft—If yes is specified, the devices attached to the top-
left USB port on the back of the thin client is enabled and available for the
operating system. If no is specified, the operating system cannot detect any
device attached this port. This INI parameter is only applicable to Wyse 5470
All-in-One thin client.
USBRearPortTopRight—If yes is specified, the devices attached to the
top-right USB port on the back of the thin client is enabled and available for
the operating system. If no is specified, the operating system cannot detect
any device attached to this port. This INI parameter is only applicable to Wyse
5470 All-in-One thin client.
USBRearPortBottomLeft—If yes is specified, the devices attached to the
bottom-left USB port is enabled and available for the operating system. If no
is specified, the operating system cannot see any device attached to this
port. This INI parameter is only applicable to Wyse 5470 All-in-One thin client.
USBRearPortBottomRight—If yes is specified, the devices attached to the
bottom-right USB port is enabled and available for the operating system. If no
is specified, the operating system cannot see any device attached to this
port. This INI parameter is only applicable to Wyse 5470 All-in-One thin client.
MaxSleepPeriod-This parameter specifies the maximum time period the thin
client is allowed to be in sleep mode. The thin client reboots after resuming
from sleep mode. If you set the value as 0, the thin client resumes from sleep
mode without rebooting. Primary unit is day, and the current unit is hour. The
default value is set to one hour, and its range is 0 to 255.
DEVICE=UsbTrace
vid_pid={device vid/pin hex format}
[max_len=500]
Specify the WTOS to trace USB device data to ftp or USB disk. For "vid_pid",
device Vendor ID and Product ID hex value, and VID is high 16 bit while
Product ID is low 16 bit.
Allows to trace maximum of eight devices at one time. For "max_len", set a
max len for capturing each USB transfer data. Default value is 128. After you
Parameters for wnos INI, {username} INI, and $MAC INI files 47