Setup Guide

Table 7. General Settings: wnos.ini files, {username} INI, and $MAC INI Files (continued)
Parameter
* Global overrides identically-named user
profile
** After sign off, user profile returns to
global value
Description
set this, you need to set option in Trouble shooting to start tracing the USB
device data.
EnableSecondaryPort= {yes, no, 1, 0}
Allows you to enable the secondary audio port on the back of the WD–19
docking station. When you set the value to 1 or yes, the audio port on the
front side of the WD-19 is disabled.
[enableEEE={0,1}]
enableEEE—This option enables or disables ENERGYSTAR 8 on your
ThinOS-based client. Set the value to 0 to disable ENERGYSTAR 8 on your
thin client. Set the value to 1 to enable ENERGYSTAR 8 on your thin client. By
default, the value is set to 1.
FactoryDefault={no, yes}
Default is no.
Yes/no option to reset the system settings to factory default. This parameter,
when set to yes, is only initialized once for each firmware change; however,
you can set to no and then reboot so the option will be initialized again.
NOTE:
If the FactoryDefault parameter value is changed to yes, the thin client
will reboot without notice to the user.
*Include=path/filename
For {username}.ini file only—Specifies to include another INI file at the
position of this parameter. Only one level of including is allowed (no nesting)
and only for a {username}.ini file.
KeySequence={no, yes}
[Ctrl+Alt+Del={no, yes}]
[Ctrl+Alt+Up={no,
yes}]
[Ctrl+Alt+Down={no, yes}]
[Ctrl+Alt+Left={no, yes}]
[Ctrl+Alt+Right={no, yes}]
[Win+L={no,
yes}]
[Alt+Tab={yes,no}]
KeySequence — Yes/no option to enable the following supported combined
keys options.
KeySequence=yes enables all of these options, each having a default of yes or
no as noted that you can change individually to the setting desired.
KeySequence=no disables all of these options regardless of the individual
settings.
Ctrl+Alt+Del — Default is no. Yes/no option to enable Ctrl+Alt+Del to lock
the thin client if the user is logged in with a password. If the user is logged in
without a password, this key sequence does not work.
Ctrl+Alt+Up — Default is yes. Yes/no option to enable Ctrl+Alt+Up to
toggle a session between fullscreen and window mode.
Ctrl+Alt+Down — Default is yes. Yes/no option to enable Ctrl+Alt+Down to
toggle between task selections.
Ctrl+Alt+Left — Default is yes. Yes/no option to enable Ctrl+Alt+Left
Arrow to lock the thin client if the user is logged in with a password. If the
user is logged in without a password, this key sequence does not work.
Ctrl+Alt+Right — Default is yes. Yes/no option to enable Ctrl+Alt+Right
Arrow to lock the thin client if the user is logged in with a password. If the
user is logged in without a password, this key sequence does not work.
Win+L — Default is no. Yes/no option to enable use of Win+L key to lock the
client.
Alt+Tab — Default is yes. This option is used for task selection.
**Language=code
[ManualOverride={yes,no}]
Language — Specifies the keyboard language to use. Once specified in a
wnos.ini file, it is saved in non-volatile memory. The code used must be
48 Parameters for wnos INI, {username} INI, and $MAC INI files