Setup Guide

Table 8. Peripheral Settings for wnos.ini Files, {username} INI, and $MAC INI files (continued)
Parameter
* Global overrides identically-named user profile
** After sign off, user profile returns to global value
Description
The PlayBackEnableList and RecordEnableList—Enables
you to specify the list of audio devices that are mapped to an
ICA session. You can separate each audio device with a
comma.
The audio device name is displayed in Event Log after you
connect and disconnect the device from the terminal. If the
actual device name does not match with the device in the list,
the device cannot be mapped to the ICA session. Setting the
value to "" results in mapping of all devices. This is similar to
no INI setting.
The terminal default device that is available in the list is set as
the default device in the session. If there are no default
devices in the list, the first valid device in the list is set as the
default device in the session.
EnableReplay— Enables or disables the audio tab in the
Troubleshooting window. You can replay pcap files of the
UDP audio.
Device=bluetooth
[Disable={yes, no}]
Set the parameter to disable bluetooth devices. The default
value is no. The value is stored into NVRAM. If you set
Disable=yes, the bluetooth devices are not initialized.
Device=MIC
[Disable={yes, no}]
Device=MIC—This option enables or disables microphone
devices. The default value is no and the value is stored in
NVRAM.
If the value is set to Disable=yes, the microphone devices are
not registered to the system.
Device=camera
[format=raw]
[width={camera supported width}]
[height={camera supported height}]
[fps={camera supported fps}]
[samplerate={0, 1, 2, 3, 4, 5}]
[optimize={
no, yes}]
[Disable={yes, no}]
[Default={camera device name}]
Specify the ThinOS local camera settings.
format — Support only for raw video type; format=raw is
fixed.
width — The width of the resolution that the local camera
supports.
height — The height of the resolution that the local camera
supports.
fps — The frame per second (fps) of the resolution that the
local camera supports.
samplerate — The software level sample rate based on fps
to optimize the performance, where the frame per second for
the camera is actually equal to the fps value multiplied by the
samplerate value. Samplerate values mean the following
sample rates:
0 — 1/1
1 — 1/2
2 — 1/3
3 — 1/4
4 — 1/5
5 — 1/6
optimize — Default is no. Yes/ no option to optimize the
width, height, and fps at 320 x 240 at 10 fps. That is, if
62
Parameters for wnos INI, {username} INI, and $MAC INI files