Users Guide

Figure 15. Network image push
3. Plug in the USB drive to the system running USB Imaging Tool.
4. Select the USB drive from the drop-down list.
If your USB drive contains other images, the screen displays the images in the table.
5. Select the operating system architecture that you want to push to the target device:
● 64 bit—Select only this option to push the 64-bit architecture based operating system to the target device.
6. To add an image to the USB drive, perform the following steps:
Option
Description
Add a new Image on
the USB drive
Perform the following steps:
a. Click the Network tab.
b. Click the + icon.
c. Enter the URL where the image files are present.
NOTE: Before configuring the USB drive for network image Push, ensure that you check
the reachability and accessibility of the URL which you enter.
d. Enter the username and password.
e. Click Add to create an image push entry in the table.
Delete existing image
path on the USB
drive
To delete the existing image path, click the Delete icon on the image path entry displayed in the
table. The image path entries are deleted from the table but are only marked for deletion in the USB
drive.
NOTE:
● In a single session, you cannot configure the local image and network image path simultaneously.
22 Using Dell Wyse USB Imaging Tool