Service Manual


4. Remove the password jumper plug, then place the plug on the CMOS jumper pins and wait approximately 5 seconds.

5. Remove the jumper plug from the CMOS jumper pins, and then reinstall the plug on the password jumper pins to enable the password feature.

6. Close the computer cover (see Replacing the Computer Cover).

7. Connect your computer and devices to electrical outlets, and then turn them on.
Back to Contents Page

NOTICE: The password jumper plug must be reinstalled on the password jumper pins in order to enable the password feature.
NOTICE: To connect a network cable, first plug the cable into the network wall jack and then plug it into the computer.