Service Manual


10. Lower the back of the assembly slightly and slide it away from the top cover, disconnecting the black round tabs on the assembly from the notches in
the swing arm.

11. Carefully guide the optical drive cable and disk sensor cable through their respective openings in the top cover.

Removing Media from the Optical Drive
If media becomes stuck in the optical drive, you can retrieve the media by opening the drive.

1. Remove the optical drive assembly (see Removing the Optical Drive Assembly.)

2. Remove the optical drive from the optical drive assembly by removing the four M2.0-mm shoulder screws that hold the optical drive to the assembly.
1
top cover (underside)
2
optical drive assembly
3
disk sensor cable
1
notch in swing arm (2)
2
tab on optical drive assembly (2)
3
optical drive cable