Service Manual


10. Replace the computer cover (see Replacing the Computer Cover).

11. Connect your computer and devices to electrical outlets, and then turn them on.
See the documentation that came with the drive for instructions on installing any software required for drive operation.

12. Enter system setup (see Entering System Setup) and select the appropriate USB for FlexBay option.
CD/DVD Drive


Removing a CD/DVD Drive

1. Follow the procedures in Before You Begin.

2. Remove the computer cover (see Removing the Computer Cover).

3. Remove the drive panel (see Removing the Drive Panel).

4. Disconnect the power and data cables from the back of the drive.

5. Slide the drive-release latch towards the base of the computer to release the shoulder screw, and then slide the CD/DVD drive out of the drive bay.
NOTICE: To connect a network cable, first plug the cable into the network port or device and then plug it in to the computer.
CAUTION: Before you begin any of the procedures in this section, follow the safety instructions in the Product Information Guide.
NOTE: If you are uninstalling your only CD/DVD drive and will not replace it at this time, disconnect the data cable from the system board and set
it aside.
1
data cable
2
power cable