Service Manual


6. Replace the drive panel (see Installing the Drive Panel).

7. Replace the computer cover (see Replacing the Computer Cover).

8. Connect your computer and devices to electrical outlets, and then turn them on.

Installing a CD/DVD Drive

1. Follow the procedures in Before You Begin.

2. Remove the computer cover (see Removing the Computer Cover).

3. Remove the drive panel (see Removing the Drive Panel).

4. Remove the existing CD/DVD drive, if applicable (see Removing a CD/DVD Drive).

5. Prepare the CD/DVD drive for installation and check the documentation that accompanied the drive to verify that the drive is configured for your
computer.

6. If no screws are attached to the drive, check the inside of the drive panel for screws and, if screws are present, attach the screws to the new drive.

7. Gently slide the drive into the drive bay until you hear a click or feel the drive securely installed.
1
drive-release latch
2
CD/DVD drive
NOTICE: To connect a network cable, first plug the cable into the network port or device and then plug it into the computer.
NOTE: If you are installing an IDE drive, configure the drive for the cable select setting.
1
CD/DVD drive
2
shoulder screws (3)