Service Manual


8. Attach the power and data cables to the CD/DVD drive.
To locate the system board connector, see System Board Components.

9. Check all cable connections and fold cables out of the way to avoid blocking airflow between the fan and cooling vents.

10. Replace the drive panel (see Installing the Drive Panel).

11. Replace the computer cover (see Replacing the Computer Cover).

12. Connect your computer and devices to electrical outlets, and then turn them on.
See the documentation that came with the drive for instructions on installing any software required for drive operation.

13. Enter system setup (see Entering System Setup) and select the appropriate Drive option.
Processor Airflow Shroud


1
drive-release latch
2
CD/DVD drive
1
power cable
2
data cable
NOTICE: To connect a network cable, first plug the cable into the network port or device and then plug it in to the computer.
CAUTION: Before you perform this procedure, follow the safety instructions located in the Product Information Guide.