Operating instructions
15
10
10
15
Basic Grill Lighting Instructions cont’d
WARNING
Should a “FLASH-BACK” fire occur in/or around the Burner Tubes, follow the instructions below. Failure to
comply with these instructions could result in a fire or explosion that could cause serious bodily injury, death,
or property damage.
- Shut off gas supply to the Outdoor Cooking Centre.
- Turn the Control Knobs to OFF position.
- Put out any flame with a fire extinguisher.
- Open hood.
- Once the Outdoor Cooking Centre has cooled down, clean the Burner Tubes and Burners according to the
cleaning instructions found on page 21 in this manual.
Smoker Burner Lighting Instructions
1. Follow steps 1 through 4 of the Basic Lighting Procedures.
2. Push and turn the Control Knob for Smoker Burner to ON.
3. Immediately press the Electric Ignitor for 3-4 seconds to light the Burner.
4. If the Burner does not light, turn the Control Knob to OFF, wait 5 minutes for gas to clear, then retry.
Assembly Instructions
Battery Powered Ignition
1. Unscrew the Ignitor Cap located on the Control Panel.
2. Place the supplied AA battery into the Ignitor Slot. Be
sure to place the positive pole (marked + on the battery)
facing toward you.
3. Screw the Ignitor Cap back onto the Control Panel
ensuring the Spring fits around the AA battery.
Electrode Check-Requires an Assistant
Before placing the cooking components into your
Outdoor Cooking Centre, ensure that the Spark
Electrode Tip is properly positioned within each Gas
Collector Box.
The easiest way to ensure this is to perform the
following Electrode Check:
1. Be sure all Control Knobs are set to “OFF”. Open the
Hood.
2. Have an assistant stand to the right of the grill and
look down at the Gas Collector Box of the Main
Burners. NEVER put your face inside hood area.
3. Press Ignitor Cap and have assistant watch for a small
blue spark within each Gas Collector Box. If a spark is
present the Electrode Tips are properly positioned.
4. If no spark is seen, the Spark Gap shown in the
illustration below right needs to be adjusted as
follows:
Using an adjustable spanner, loosen the inside Nut
just until the Gas Collector Box can be manoeuvred
and turned upward. The gap between the Spark
Electrode Tip and Spark Receiver should be
approximately 5mm.
If the gap is wider than 5mm, use a pair of long nose
pliers and gently squeeze the Gas Collector Box until
the gap is correct. Return the Gas Collector Box to its
original horizontal position, secure the inside Nut
and try the Electrode Check again.
Look for spark
De’Longhi Outdoor Cooking Centre - Model DELUX8BIS21/DELUX8BIS21NG De’Longhi Outdoor Cooking Centre - Model DELUX8BIS21/DELUX8BIS21NG
Preparing the Cooking Surface
Important: Before cooking on your Outdoor Cooking Centre for the first time, wash the Solid Plate, Open Grills
and Warming Rack with warm, soapy water. Rinse and dry thoroughly. After cooking is completed, turn knobs
to HIGH setting for about three to five minutes to burn off excess grease or food residue.