user manual
Install the hook on the aesthetic fascia panel and
Ÿ
put the hook into the slot of the outer door of
dishwasher (see below).
Installation
Page 9
Outer Door
The hook is lifted from position 1 to the appropriate place,
then pushed right to position 2, making the panel and the
outer door align.
2
1
2
1
ST4 screw
Cover
Spacer for aesthetic panel
ST4 screw
Hook for aesthetic panel
Aesthetic panel
Outer door of
dishwasher
Hook for
aesthetic
panel
A A
B B
Tension adjustment of the door
The door springs are set at the factory to the
Ÿ
proper tension for the outer door. If an aesthetic
fascia panel is installed, you will have to adjust the
door spring tension. Rotate the adjusting screw to
drive the adjustor to strain or relax the steel cable
(see below).
Adjust the door spring tension until the door
Ÿ
remains balanced in the fully-opened position.
relax
After positioning of the panel, fix the panel onto the
Ÿ
outer door by screws and bolts (See following
diagrams).
Page 20
NOTE:
If you open the door during a wash cycle, the machine
will pause. The LED Display Window will stop blinking
and the buzzer will sound every minute unless you
close the door. After you close the door, the
dishwasher will continue working after 10 seconds.
If display window shows error codes after a warning
sound (see page 25 for “ERROR CODES"), that
indicates the machine is out of order, please turn off
the main power and water supply before calling for
service.
FORGET TO ADD A DISH?
A forgotten dish can be added at any time before the
detergent cup opens.
1. Open the door a little to stop the washing.
2. After the spray arms stop working, you can open
the door completely.
3. Load the forgotten dishes.
4. Close the door, the dishwasher will start running
again after 10 seconds.
WARNING! It is dangerous to open the door when
washing, because the hot water may scald you.
AT THE END OF THE WASH CYCLE
When the working cycle has finished, the buzzer of the
dishwasher will sound for 8 seconds, then stop. Turn
off the appliance using the ON/OFF button, shut off
the water supply and open the door of the dishwasher.
Wait for a few minutes before unloading the
dishwasher to avoid handling the dishes and utensils
while they are still hot and more susceptible to
breakage. They will also dry better.
Switch off the Dishwasher
When the digital display shows ‘-:--’ (remaining
program time), the program has ended.
1. Switch off the dishwasher by pressing the ON/OFF
button.
2. Turn off the water tap!
Open the door carefully
The dishes should be allowed to cool down around 15
minutes before removing from the appliance.
Open the dishwasher's door, leave it ajar and wait a
few minutes before removing the dishes. Dishes will
be cooler and the drying will be improved.
Unloading the Dishwasher
It is normal that the dishwasher is wet inside.
Empty the lower basket first and then the upper one.
This will avoid water dripping from the upper Basket
onto the dishes in the lower one.
Using Your Dishwasher