Specifications

32
STATUS CODE
-09
DESCRIPTION
Both forward and reverse directional switches are closed
at the same time.
No
MEMORY
RECALL
CONTROL
TYPE
STATUS INDICATION CRITERIA
This status code will be displayed when TB5 and TB6
are greater than 60% of battery volts at the same time.
Traction
STATUS CODE
-08
DESCRIPTION
Accelerator input voltage too low on power up after
initial key switch closure.
No
MEMORY
RECALL
CONTROL
TYPE
STATUS INDICATION CRITERIA
This status code will be displayed when the accelerator
input voltage at TB1 is less than 3.0 volts, and any of
the following connections are opened and closed,
battery plug or seat switch or key switch.
Traction
Figure 1
Figure 1
SYMPTOM
Forward or reverse contactor does not pick up.
POSSIBLE CAUSE
Accelerator input mis-adjusted or defective.
 Input voltage at TB1 should be more than 3.0 volts.
Adjust or replace accelerator unit to insure that the
voltage at TB1 is more than 3.0 volts before depress-
ing pedal.
Short circuit between battery negative and TB1 in accelera-
tor input circuit.
 Disconnect wire from TB1. Check for short circuit
from wire to battery negative. Resistance should be
greater than 4.7K ohms.
Defective Card
 Disconnect wire from TB1. Measure voltage from
TB1 to negative. Voltage should be greater than 4.5
volts, if not, replace card.
SYMPTOM
Forward or reverse contactor will not pick up.
POSSIBLE CAUSE
Forward or reverse directional switch welded closed or mis-
adjusted to be held closed.
 Replace or adjust directional switches to insure that
they open when directional switch is returned to
neutral.
Short circuit between battery positive and TB5 and/or TB6.
 Disconnect wires from TB5 and TB6 and check wires
for short circuit to positive side of directional switch.
Defective card
 Disconnect wires and measure voltage at TB5 and
TB6 . Voltage should be less than 60% of battery
volts.