Specifications

68
DESCRIPTION AND LOCATION
Z PLUG
Y PLUG
B PLUG
A PLUG
EV100 LX/LXT
FUNCTION SET-UP PROCEDURES:
Warning: Before making any adjustments to the control
you must consult the operating and maintenance instruc-
tions supplied by the vehicle manufacturer. Failure to
follow proper set up instructions could result in
misoperation or damage to the control system.
With the Handset connected , hold down the CONT key and
turn on the key switch. This will place you in the set up mode,
ready to monitor or adjust control function settings.
NOTE: The term push, means to depress key for approxi-
mately one second.
SET UP MODE
Action Display shows Remarks
Hold down CONT, 8888 Segment check
turn on key displayed
Push function U 005 Selected
number function number
is displayed
After one second 085 Stored value for
time delay the function is
displayed
Push CONT 085 Displayed value
will blink
Change value with 125 Value changes
adjustment knob while blinking
Push STORE 125 New value
stored and
blinking stops
Push ESC 8888 Segment check
displayed
At this point another function can be monitored/changed
by pushing another function number, or the vehicle can be
placed in the run mode by holding the ESC key down for
one second or longer. The display will return to either the
diagnostics mode or the BDI display or a blank display (
if BDI is not used and there are no fault codes). The
vehicle can now be operated with the handset connected
or the handset can be disconnected before operation.
NOTE: You can return to the segment check mode at any
time, by holding down the ESC key until 8888 appears in
the display.