Specifications

74
Example: If plug distance current Function 5 is set at 500
amps, then set pedal plug current at 500 amps. With this
setting pedal position will have no effect on plugging
distance.
FUNCTION 17 CARD TYPE SELECTION
( Push CONT and 2 )
This function allows for the selection of the card type used for
your vehicle's application. The table below shows the setting
to select card application type depending on which control
card is used.
EV100 Standard
Function with FW
STD C/L 0 to 4
High C/L 5 to 9
STD C/L
(Auto plug) 10 to 14
High C/L
(Auto plug) 15 to 19
EV200 Standard
Function with FW
STD C/L 20 to 24
STD C/L
(Auto plug) 30 to 34
Settings for these function should be made in between the
values shown.
Warning: These settings must be changed by authorized
personnel only, following instructions supplied by the
manufacturer. Card type selection must be made within
the capabilities of the SCR control panel used and the
supporting electro-mechanical devices. Failure to com-
ply with proper application standards could result in
misoperation or damage to the control and/or motors.
FUNCTION 18 STEER PUMP TIME DELAY
( Push CONT and 3 )
This function allows for the selection of steer pump contactor
pick up input, either seat switch or directional switch closing
and adjustment of the time delay for the contactor drop out.
Pick up on seat switch closure and time delay drop out on
seat switch opening.
Range 1.5 to 65 seconds
Setting Between 0 and 128
Resolution .5 seconds per set unit
Example: Setting of 20 = 10.5 seconds
Pick up on directional switch closure and drop out time
delay on directional switch opening.
Range .5 to 63 seconds
Setting 129 to 255
Resolution .5 seconds per set unit
Example: Setting of 149 = 10.5 seconds
Drop out will be 1.5 seconds after the seat switch opens.